IMPORTANT DISCLAIMER

Samples - Please note that the samples supplied by Rimex Metals are for promotional purposes only and are not to be used as control materials for goods supplied. If control samples are required for a specific order Rimex needs to be notified in advance.

Patterns - The pattern definition will vary between thickness & type of steel and can therefore differ to samples. Pattern definition can also vary between batches of steel and with separate orders.

Colour - The nature of coloured stainless steel is that the colour and/or tone may vary in different lighting conditions, between batches of stainless steel and production runs. It is often necessary to agree to control samples prior to manufacture.

On larger orders it is advisable to agree to control samples to define an agreeable colour range prior to the placing of an order. Unless control samples are agreed Rimex is not responsible for differences in tone and appearance of the ColourTex® product.

Suspension holes - Due to the nature of the manufacturing process all ColourTex® products will be supplied with holes approximately 5mm (0.197'') in diameter that run down the length of one side of each sheet every 1,000mm (39.3'').

Protective Film - Unless ordered to the contrary all material is coated with standard commercial protective tape. No warranty is provided by Rimex as to the suitability of coating used. Copies of appropriate data sheets are available upon request. If a warranty is required the customer should deal direct with a protective tape supplier and notify Rimex of the coating to be used. The use of nonstandard protective tape might be an additional cost to previously quoted prices. Protective tape should be removed as soon as practical and should not be exposed to direct sunlight and temperatures that might cause delamination of adhesive on the coating. The customer is always advised to seek information from the coating manufacturer. Rimex cannot provide information or warranties in respect of protective tapes.